I have tried anydvd, dvd decrypt, dvd shrink and dvdfab. Nothing is working. any ideas???

Please help.

I had no problem with the latest any dvd with dvd decrypter. Check you any dvd version make sure that it's the latest.

thanks doc. I will look and see.

No problems with AnyDVD and CloneDVD2.....

same as bilbo65 - no problem but did just movie

Same here no problems.

no problems with my copy of 'walk the line' region 1....latest anydvd with dvd shrink....

as always clonedvd strikes again

When I try to to shrink walk the line from the files ripped by the anydvd ripper, I get the error: Failed to open VTS_06_0.VOB, overlapped i/o operation in progress, on the initial scan.

It does appear that I can can the dvd directly with shrink, open disc vs open files.

I have not completed the shrink direct from the dvd as of yet.

anydvd 5.9.4.1 registered

The AnyDVD ripper is intended for repairing poorly structured DVDs which DVD Shrink will choke on. To my knowledge after having used AnyDVD & DVD Decrypter yesterday to rip Walk the Line R1 NTSC, it went fine. The AnyDVD ripper (FixVTS) would be something you may want to use on say Disney's latest Lady & the Tramp DVD. No special settings needed, either copy the VIDEO_TS folder and Shrink or use Decrypter with AnyDVD with the recommended settings.

I used the anydvd ripper to rip to the drive, and got the error above.

I used shrink directly on the disk with anydvd decrypting, and when I played the disc, the first half of the movie had no audio, later the audio started working normally.

Backed up "Walk the Line" Region 1 using AnyDVD ver 5.9.4.1 and DVD Shrink deep analysis with no problems.

Same here.

Hello Folks,

Just made a backup copy of Walk The Line (R1) (USA) using the AnyDVD v5.9.4.1/ CloneDVD v2.8.9.2 combination without any problems.

Best Regards,
bjkg

I just used any dvd 5.9.4.1 dvd decrypter then used dvd shrink and it went flawless without deep analysis.

Ditto on anydvd and shrink. No problem

I had problems with Walk the Line region 1. Must be some defective discs out there. Got a cyclonic redundancy error in VTS_06_5.VOB. Ripping would always stop at 65% using both Shrink and CloneDVD. I finally was abe to rip with Decrypter set to ignore read errors. I then was able to use CloneCD and process and burn. Using AnyDVD 5.9.4.1. and Clone 2.8.9.2.

Bad write errors on the original or if it is dirty can do this. I had the same problem with Independece Day 2 disc colletion returned it for another and copied with no problems you might want to do the same return the movie for another copy.

I have had great time using anyDVD and CloneDVD2.Just keep up with the updates.Never had a miss.....Sometimes I use Shrink with Dvd decrypter..Some say CloneDVD2 makes a better copy than Shrink....I just can't tell, they are so clear.Iam real pleased...Worth the money.