I purchased Total Training For Premier Pro 2.0 and I would like to make a backup set of DVD's to work off of, and save my originals. It's an expensive program. When I attempted to do this with Clone DVD .. I got the following message:

Unable to read video files from E:?
E:/VIDEO_TS.IFO: unable to open file.
The system cannot find the file specified.
Please be sure that all required files are available and try again.


There are a total of five DVD's in the set.

Any advice?

Thanks,
CometBaby

Yes: If you already use AnyDVD 6 and it doesn't work, use CloneCD to create a 1:1 copy.

Those are not DVD Movies, they are programs stored on DVD....

Then what Tru said should work, CloneCD should be able to make a 1:1 copy of the DVDs.

Hi guys,

What you suggested worked perfectly until I got to the last DVD. That was the *only* one where I once again, got the message that there wasn't enough room. I checked to make sure I had put a DVD in, and I had.

Since it was the last one, and basically *Projects* .. I just told it to write until it reached the end of what it could write. I haven't checked to see what is missing yet.

I'm not sure why the last DVD did not copy over like the others but maybe it had more data on it .. ?? Any ideas about that?

Thanks, so much for you kindness and your help. :-)

Sincerely,
CometBaby

Possible dual layer for the last DVD, and you are using a single layer to copy.