Hi

I have just installed Vista 64-bits. When I rip a CD with EAC my computer is very slow, I can barely use it. I didn't have this problem when XP was installed.

My computer is set up like this:

Intel C2D E6600 2.4 GHz
Intel Motherboard P965
RAM/Memory: 4029 MB
CD/DVD Rom drives: Plextor PX-755A and PX-760A
PSU: Corsair 620W
HDD: Seagate 7200.11

Is there some kind of setting I must do to make EAC run, without slowing down the whole system?

With kind regards: Jens

Hi there,
I just checked the EAC forums for ideas - I guess you posted the same question there
Is it fixed now?

Installed my LG GSA-H10N, and now everything is back to normal. Just like when I used XP. Perhaps Vista doesn't like Plextor drives That is really sad, just loved my Plextor.

Have you tested with both the Vista and the chipset manufacturer's IDE drivers (if available)? I remember when I ran Vista RC2, I had poor performance using the Vista driver with a Samsung SATA hard drive, only in 32-bit, not in 64-bit.

Also, I noticed a difference between 1.02 firmware and newer releases in how my PX-755A behaves on IDE (much cleaner buffer when burning DVD with 1.02). You may want to give this a try if nothing else helps.